Tiling Hoister

Tiling Hoister
Tiling Hoister
Tiling Hoister
Request a Quote

After pre-curing, the mould will be transferred to tiling area. The hoister should grasp mould to rotate it with 90 degrees, then the clamping arm controlled by hydraulic motor will loosen to put side wall and cake together on the cutting cart. Then the empty mould base will be sent back to the side wall conveyor line, which is assembled with a free side wall to become a complete mould and ready for the next pouring processing.

The tilting table is installed at the end of the cutting section. By using this equipment, the waste material at the top and bottom of cake can be removed. The tilting table is composed by a table, guide pillar, hydraulic system, and control system.

The cut concrete block, together with the side plate is conveyed to the table by the semi-finished product hoist. Then the side plate will be fixed, while the block will be turned by 90° by the hydraulic system. Thus the waste material can fall off automatically. After that, the table rotates back to the original position, and releases the side plate.

To make our tilting table more reliable, we use premium oil cylinder. Thus the table can tilt stably and synchronically, while the tilting speed is also adjustable. The whole tilting process doesn't need the traveling crane, and little operation is needed from the workers.

Related products
Send Message
Inquiry
Inquiry